Location: Home > Products > Dressing Tools

  • Single Point Diamond Dresser1
  • Single Point Diamond Dresser
  • Single Point Diamond Dresser
  • Single Point Diamond Dresser

Single Point Diamond Dresser

Feature:

For normal abrasive wheels and abrasive wheels for Bearing, processing of Input shaft / Output shaft and procession of Crankshaft and Gear.

We're here to help:
Easy ways to get the answers you need.

product list

Diamond Saw Blades
Diamond Grinding Wheels
Diamond Drill Bits
Diamond Polishing Pads
Diamond Segments
Cutting Tools
Grinding Tools
Polishing Tools
Dressing Tools
Abrasive Tools
Bonded Abrasives
Coated Abrasives
Refractory

send message

  • Product introduction
  • Specification
  • Inquiry
Application:
- For normal abrasive wheels and abrasive wheels for Bearing 
- For processing of Input shaft / Output shaft 
- For procession of Crankshaft and Gear 
- For abrasive wheels for procession of other car parts

Guideline for Single-Point Diamond dressers :

Considerable care should be taken in mounting the diamond dresser in position. Diamonds are sensitive to shock and impact.
The dresser must be clamped rigidly in place to avoid vibration once dressing begins.
An ample supply of coolant should be directed at the diamond point before dressing begins, as the sudden application of coolant to the diamond once it has heated up can cause it to shatter.
The diamond holder should not be set directly on the center of the grinding wheel, but at an angle of 5-15 to the direction of rotation of the wheel so that it appears to be "trailing"
At normal wheel peripheral speeds, dressing rates of approximately 20-25 m/sec can be achieved.
The maximum depth of cut achieved per dressing pass is 0.03 mm or on fine grit wheels, 
approximately 0.005-0.01 mm.
The cross feed rate is dependent upon grit size and can have a marked influence on the quality of the finish imparted to the grinding wheel surface. The lower the feed rate, the finer the surface finish.  
Grinding Wheel Grit Size Feed rate in mm/rev
30 - 46 0.60 - 0.30
50 - 120 0.30 - 0.10
180 - 320 0.10 - 0.02

Manufacture by sintering a selected diamond crystal with metal matrix into a steel shank.

inquiry

Please feel free to submit your inquiry information to us. We will reply you in 24 hours.

+86 371 63355891